A download is done to download your terminal file parameters to your terminal. This is usually required when you are activating a new terminal or have made updates to features on your terminal and would like to enable it.
Before Authorizing and Initiating a Download
› Make sure there are no open batches
› Make sure internet is connected to the device
› Make sure the external PIN Pad, if applicable, is connected to the device
Performing Download WITHOUT new TMS Identifier / Signature
• Press the [.,#*] Key
• Key in Password and press [Enter] if prompted
• Select [4 - Maintenance]
• Select [1 - Download]
• Select [2 - Start Download]
• Select [1 - Software/Param]
Once authorized, the terminal will communicate out for the download. Once the download is complete, the terminal will reboot, print a receipt indicating the download was successful, and reboot once more.
The download is now complete.
Performing Download WITH new TMS Identifier / Signature
• Press the [.,#*] Key
• Key in Password and press [Enter] if prompted
• Select [4 - Maintenance]
• Select [1- Download]
• Select [1 - Setup]
• Select your communication type -- Press enter (green button)
There will be several menus you pass through where you will not change anything and look for the TMS identifier or Signature field
• Select SSL ON - Press enter (green button)
• Ensure you see Host URL - termupdate.elavon.net
• Ensure you see Host Port 6443
• Scroll down to Enter TMS Identifier (a.k.a. Signature) - insert the new TMS file # provided to you - Press enter (green button)
Press on the signature field, pull open the full keyboard, press yellow to remove current TMS, enter in new TMS, press green button, press green button again.
You will be back at the download menu
• Select [2 - Start Download]
The terminal will reset a few times and toward the end print a receipt that says "parameters update successful" and reset a final time.
Complete a Key Load.
Once terminal is back on main screen
• Press [.,#*]
• Key in Password and press [Enter] if prompted
• Select [8- Host Management]
• Select [1 -EMV Public Key Load]
• Select [1 -EMV Public Key Load]
Terminal will download and finish by saying succeeded
Press Enter (green button)
Hit cancel (red button) until back at main screen
To view Last Download
• Press the [.,#*] Key
• Key in Password and press [Enter] if prompted
• Select [4 - Maintenance]
• Select [3 - Last Download]
To view current TMS identifier (Signature)
• Press the [.,#*] Key
• Key in Password and press [Enter] if prompted
• Select [4 - Maintenance]
• Select [4 - Display Params]
• Select the + next to Maintenance and scroll down to Signature